Maintained Active Implant

Hard implant is a unique dental implant developed after thorough research related to the ongoing quality of the connection between the bone and the dental implant.
Our development team sought a solution that would extend as far as possible the life of the connection between the bone and the implant everything to ensure long-term quality restoration or almost infinite. In the development process is taken into consideration that even if we use the finest dental implant in the world, it is agreed that this object is a passive metal implant which has no lasting benefit or active contribution of osteointegration. from this point of view, we developed Hard implant based on our spiral implant line, but hollowed and with few points of holes in the body, all for the transport or injection of fluid-gel that contain regeneration ingredients.

Inventive thinking
As presented in the introduction about the Hard family implant.
The goal is to use this unique dental implant as a tool for transporting liquids and \ or special solutions designed to refresh the soft bone in the jaw. Special holes at the bottom of the implant body and graft are used for transporting liquids from the implant after successful implantation process and indefinitely when the implant is functioning as a basis for dental rehabilitation on the one hand, and as a tool for conveying the same fluid causes the processing of soft bone regeneration.
This innovative Hard implant is unique and exclusive to our company and reflects technological innovation and a major breakthrough in relation to prolong the life of dental implants and extending the medical care success and life quality of the patient.
The proposed maintenance using Hard dental implant \ device contributes to bone reconstruction and revival of the soft tissues.
The procedure involves performing the proposed maintenance is simple and friendly to the doctor and patient, and is in fact part of the routine care and maintenance required after dental implants procedure from time to time.

Surface treatment unique approach
Our company has adopted the method of surface treatment based on technology SLA or the RBM using quality materials to create Topography required on the one hand and on the other hand has chosen , principle, not to use chemicals and industrial pollutants which the results in their use may be harmful after months/years during the break-up of chemicals.
The company decided to use citric acid seem natural stabilized as a key component in the process of removing residues media which was sprayed on a dental implant during surface treatment .
The use of acid seem natural ensures that the implant will be absorbed very well and that will avoid situations of rejection of implants resulting from acid treatment consisting of aggressive industrial chemicals that have the feature break-up after a certain period.
This process is unique to our company and is based on years of experience and hundreds of thousands of implants manufactured and implanted around the world.implanted around the world.

  ∅3.30 ∅3,75 ∅4.20 ∅5.00 ∅6.00
6 mm X
8 mm
10 mm
11,5 mm
13 mm
16 mm X

The recommendations presented in this drilling Protocol, based on long experience of specialists in the world. However it is important to examine each case on its merits based on the physician’s ability to perform the procedure, and the state of the patient’s jaw implant transpires with the beginning and there may be changes according to the situation.
In principle, we recommend using a drill that its diameter smaller than the diameter of the implant, in the case of soft bone condition. Also, consider using a similar drill diameter implant intended for implantation in the case of hard bone in order to avoid trauma to the bone and ensure rapid bone building around the implant.

  Ø2.0 Ø2.5 Ø2.8 Ø3.2 Ø3.65 Ø4.2 Ø4.5 Ø4.8 Ø5.2